WIP LoRAType

variants/lora_type/platformio.ini

@@ -0,0 +1,15 @@
+[env:lora_type]
+extends = esp32_base
+board = esp32doit-devkit-v1
+board_level = extra
+build_flags =
+  ${esp32_base.build_flags}
+  -DLORA_TYPE
+  -DEBYTE_E22
+  -Ivariants/lora_type
+  -DEPD_HEIGHT=200
+  -DEPD_WIDTH=200
+  -DM5_COREINK 
+lib_deps = 
+  ${esp32_base.lib_deps}
+  zinggjm/GxEPD2@^1.4.9

variants/lora_type/variant.h

@@ -0,0 +1,37 @@
+#define BUTTON_PIN 39  // The middle button GPIO on the T-Beam
+#define BATTERY_PIN 35 // A battery voltage measurement pin, voltage divider connected here to measure battery voltage
+#define ADC_CHANNEL ADC1_GPIO35_CHANNEL
+#define ADC_MULTIPLIER 2.0 // (R1 = 27k, R2 = 100k)
+#define LED_PIN 33           // add status LED (compatible with core-pcb and DIY targets)
+
+#define LORA_DIO0 RADIOLIB_NC  // a No connect on the SX1262/SX1268 module
+#define LORA_RESET 16 // RST for SX1276, and for SX1262/SX1268
+#define LORA_DIO1 4  // IRQ for SX1262/SX1268
+#define LORA_DIO2 26  // BUSY for SX1262/SX1268
+#define LORA_DIO3     // Not connected on PCB, but internally on the TTGO SX1262/SX1268, if DIO3 is high the TXCO is enabled
+
+#define RF95_SCK 18
+#define RF95_MISO 19
+#define RF95_MOSI 23
+#define RF95_NSS 5
+
+#define USE_SX1262
+
+#define SX126X_CS 5 // NSS for SX126X
+#define SX126X_DIO1 LORA_DIO1
+#define SX126X_BUSY LORA_DIO2
+#define SX126X_RESET LORA_RESET
+#define SX126X_RXEN 25
+#define SX126X_TXEN RADIOLIB_NC
+#define SX126X_DIO2_AS_RF_SWITCH
+
+#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+
+#define USE_EINK
+#define PIN_EINK_EN -1   // N/C
+#define PIN_EINK_CS 15   // EPD_CS
+#define PIN_EINK_BUSY 27 // EPD_BUSY
+#define PIN_EINK_DC 12   // EPD_D/C
+#define PIN_EINK_RES 32  // Connected but not needed
+#define PIN_EINK_SCLK 14 // EPD_SCLK
+#define PIN_EINK_MOSI 13 // GxEPD2_EPDEPD_MOSI