* LR11x0: try XTAL before TCXO when oscillator type is uncertain
On boards with TCXO_OPTIONAL, a TCXO-first attempt either hangs RadioLib's
calibration wait forever on a bare/non-TCXO module (unpatched upstream), or
costs a slow failed attempt before falling back even once that's fixed with
a timeout. Measured on hardware: XTAL succeeds immediately on a bare module
(~350ms) and fails fast and cleanly on a genuine TCXO module (~300ms,
RADIOLIB_ERR_SPI_CMD_FAILED), so trying XTAL first is a strict improvement
for hang-avoidance regardless of which oscillator is actually present.
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
* compacted
* fix review comment
* fix femtofox switches
* correct the correction
* 13
* 3s timeout
* Treat SPI_CMD_TIMEOUT as an LR11x0 init failure
The BUSY watchdog breaks RadioLib's wait, so the next bounded transfer
returns SPI_CMD_TIMEOUT rather than SPI_CMD_FAILED. Only the latter was
checked, so a watchdog-triggered failure fell through to getVersionInfo(),
setRfSwitchTable() and startReceive() against an unresponsive chip.
Also use Throttle::isWithinTimespanMs() for the watchdog's elapsed-time
check instead of raw millis() arithmetic.
* Drop the BUSY watchdog and probe XTAL before TCXO
The watchdog bounded RadioLib's unbounded BUSY wait in LR11x0::config() by
having LockingArduinoHal::digitalRead() report a stuck pin low exactly once.
That let a TCXO-first attempt fail cleanly rather than hang, but it meant
lying to RadioLib about a GPIO from a HAL shared by every radio driver.
Ordering the attempts XTAL-first avoids the hang outright instead: attempt 1
configures no DIO3 Vref, so there is no calibration wait to get stuck in, and
the TCXO fallback is only reached on a module that answered and refused XTAL.
Attempts are now XTAL, then TCXO, then a settling retry on whichever
oscillator was settled on - after a fallback that is a second TCXO attempt.
Only TCXO_OPTIONAL builds probe XTAL; a variant that declares a Vref
unconditionally still goes straight to it and never probes XTAL at all.
SPI_CMD_TIMEOUT stays a failure alongside SPI_CMD_FAILED: a bounded
per-command BUSY wait in Module::SPItransferStream() reports it in its own
right, independently of the removed watchdog.
* Drop a stray tab from the promicro TCXO readme
trunk fmt: prettier flags the whitespace-only line inside the <summary>
block, which was the only failing check on the PR.
---------
Co-authored-by: Claude Sonnet 5 <noreply@anthropic.com>
Co-authored-by: Thomas Göttgens <tgoettgens@gmail.com>
* added femtofox configs
* Rename bin/config.d/femtofox_Waveshare-SX126X-XXXM_AI-Thinker-RA-01SH.yaml to bin/config.d/femtofox/femtofox_Waveshare-SX126X-XXXM_AI-Thinker-RA-01SH.yaml
* moved femtofox configs to subdir
