mirror of
https://github.com/alexhopeoconnor/firmware.git
synced 2026-10-04 03:18:10 +10:00
54d6ce833e
* gps: avoid pow() in GPS_HARDSLEEP threshold heuristic GPS::down() used pow(seconds, 1.22) to pick between GPS_SOFTSLEEP and GPS_HARDSLEEP - a curve fit the surrounding comment already describes as "not particularly accurate". On flash-constrained builds where this was the only pow() call site (e.g. wio-e5), it single-handedly pulled in the full double-precision libm pow/rem_pio2 chain for a heuristic threshold decision. Replaces it with gpsHardsleepThresholdMs(), a piecewise-linear lookup over the same curve, sampled at 16 points and verified to track the original formula within ~0.5% for inputs >=10s and ~1.6% for 5-10s (worse only in relative terms below 5s, where the absolute difference is at most a couple of seconds - negligible against update intervals measured in tens of seconds to hours). Signed-off-by: Andrew Yong <me@ndoo.sg> Assisted-by: Claude Sonnet 5 <noreply@anthropic.com> * gps: trim comments to repo convention (1-2 lines) Addresses a CodeRabbit nitpick: the explanatory comments in GPSUpdateScheduling.cpp and test_gps_update_scheduling/test_main.cpp had grown into multi-line blocks with provenance detail that belongs in the commit message, not inline. Trims each to 1-2 lines, keeping only the essential rationale/bounds. Signed-off-by: Andrew Yong <me@ndoo.sg> Assisted-by: Claude Sonnet 5 <noreply@anthropic.com> * Refactor main function to setup and loop for tests Signed-off-by: Thomas Göttgens <tgoettgens@gmail.com> * gps: extend the hardsleep threshold table below 5s and tighten its tests The 0s-to-5s chord read 42% high at 1s, 22% at 2s and 12% at 3s, against the ~1.6% the comment claimed. Adding 1s, 2s and 3s sample points brings the worst error below 10s to 1.60% at 7s. Above 10s it is 0.55% at 728s, unchanged. Tests: sample off-breakpoint values only, including both worst-error inputs (7s and 728s). Replace the 3000ms absolute floor, which made the 1s assertion unfalsifiable given a true value of 2750ms, with 2% and 0.75% bounds. Add breakpoint-exactness and clamp-boundary coverage. --------- Signed-off-by: Andrew Yong <me@ndoo.sg> Signed-off-by: Thomas Göttgens <tgoettgens@gmail.com> Co-authored-by: Austin <vidplace7@gmail.com> Co-authored-by: Thomas Göttgens <tgoettgens@gmail.com>
Meshtastic Firmware
Overview
This repository contains the official device firmware for Meshtastic, an open-source LoRa mesh networking project designed for long-range, low-power communication without relying on internet or cellular infrastructure. The firmware supports various hardware platforms, including ESP32, nRF52, RP2040/RP2350, and Linux-based devices.
Meshtastic enables text messaging, location sharing, and telemetry over a decentralized mesh network, making it ideal for outdoor adventures, emergency preparedness, and remote operations.
Get Started
- 🔧 Building Instructions - Learn how to compile the firmware from source.
- ⚡ Flashing Instructions - Install or update the firmware on your device.
Join our community and help improve Meshtastic! 🚀
Stats
